Fader is a level control on a mixing console or DAW channel, commonly operated by moving a slider. It changes how much of that channel reaches its assigned destination.

A fader is not the same as the input gain control. The input stage can distort before the fader has any opportunity to turn the channel down.

What the fader controls

A channel fader normally sets the level of the signal at a particular point in the channel strip, usually near its output. Its actual position in the signal path depends on the mixer and its routing configuration. A fader set to unity gain passes the signal at the fader stage without intentional boost or attenuation; unity does not guarantee a safe recording level or a clipping-free downstream bus.

Moving a fader changes the balance between channels. It does not necessarily change the recording level of a microphone, the amount sent to a pre-fader monitor mix, or the input level of a processor placed before the fader.

Faders in recording and mixing

Balance the lead vocal against drums and instruments with channel faders, then check the destination bus meter. If a track clips at its input, reduce input gain rather than hiding the problem with the fader. If a subgroup or output clips, investigate the level feeding that stage.

A fader can also be automated so its position changes over a song. Short rides can bring a quiet word forward without processing the entire vocal with additional compression.

Before automating a fader for a quiet word, consider whether the move also changes downstream processing. A compressor inserted before the fader will not respond to the automation the same way as a compressor placed after it. The audible result depends on the order of the controls, not just the number shown on the fader cap.

Imagine a vocal feeding the stereo mix and a separate headphone bus. With the headphone send set pre-fader, lowering the vocal’s channel fader changes the mix but may leave the singer’s headphone level unchanged. With a post-fader send to a reverb, the same move usually reduces the amount of vocal reaching that reverb. These differences are intentional, not mixer faults.

When a fader move affects another route

The channel’s meter and the fader’s markings describe different things. A meter displays a signal level at a particular measuring point. The fader tells you how much level adjustment is being applied at its position in the signal path. A meter showing a high signal is not evidence that its corresponding fader is set too high.

On most consoles, the marked 0 dB point means unity, not silence. Positions below it attenuate the signal, and some faders provide a limited amount of gain above unity. A fader scale is usually nonlinear: a small movement near unity can represent a relatively small level change, while the same physical movement near the bottom may represent a much larger one. This gives the engineer finer control where normal mixing adjustments are made.

Reading the fader scale

Common fader mistakes

“Zero on the fader means silence.” On most mixer scales, 0 dB indicates unity gain; the fully lowered position represents silence or effective attenuation. “Pulling a fader down fixes clipped recordings.” It does not repair distortion already recorded or generated before the fader.

When a headphone mix does not respond to the main channel fader, inspect the send tap: a pre-fader send is designed to behave independently.

Check the level at each stage

Play the loudest section, inspect the channel input meter, then the channel output, subgroup, and main output. Adjust the control at the stage that is actually overloaded. A lower fader is useful for balance but does not compensate for clipped source material.

For the manufacturer implementation of these controls, see the Apple Logic Pro documentation. Other mixers may use different signal paths or terminology.